Table of Contents
Advertisement
DC2R Remote Training System With LCD display and of 300 meters range
◎
Controller
Features :
1.100 levels of vibration.
2.100 levels of shock(optional).
3.The levels can be altered by use of up & down button.
4.A tone button activates a tone on the receiver collar.
5.The system can be used for 1 or 2 receivers' collars.
6.Four modes --shock, vibration, light and beep mode, meet your different training needs.
7.300 meters usage range in open areas.
8.Power saving design: the controller enters sleep mode after 20s of no operation, and wakes up by
pressing MODE for 1s; the receiver enters sleep mode after 20s no movement, and wakes up when
moving.
Advertisement
Table of Contents
Summary of Contents for AGPtek DC2R
- Page 1 DC2R Remote Training System With LCD display and of 300 meters range ◎ Controller Features : 1.100 levels of vibration. 2.100 levels of shock(optional). 3.The levels can be altered by use of up & down button. 4.A tone button activates a tone on the receiver collar.
- Page 2 ◎ Getting charge 1. Charge the controller Connect the charger connector to the charging jack. After plugging the charger into a standard outlet， the red LED light inside the transmitter will be lighted. Charge the controller at least 6 hours for the first charge.
- Page 3 3. Then press the Y button of controller immediately and you can hear a “beep” again. That shows the item is paired successfully. If not, please remove the batteries of collar and install them once again, and try the above steps. Matching the second collar If you have another collar, please follow the next steps to finish matching.
- Page 4 ◎ Using The Four Models (after encoding is completed) Four modes can be altered by pressing the MODE button of controller. 1. Shock Model Test the static shock function （1) Take out the test bulb from the package and put it on the Receiver collar’s contact points. (2) Press MODE button of controller, switch to Shock Mode (the small icon can be seen at the upper left of the LED screen).
- Page 5 (2) Thread the collar strap through the slots on the receiver, and tie it to the dog. 2. Vibration Model (1) Press Mode button of controller, switch to Vibrate Mode (the small icon can be seen at the upper part of the LED screen). Press UP/DOWN button on the right side confirming LCD display is not to be 0. (2) Press Y button, Receiver collar will vibrate, that means Vibration function works.
- Page 6 (1) Press Mode button of Controller, switch to LED light Mode (the small icon can be seen at the upper right of the LED screen). (2) Press the Y button and then the receiver collar and the indicator light of controller will flash at the same time, signifying that the LED Light function works.
- Page 7 2. Practice using the electronic remote training collar. Start at the lowest level of stimulation and observe your dog when you activate it. The dog's ear might twitch or he may move his head as if trying to get away from the collar. If your dog doesn't respond at the lowest stimulation, slowly turn the transmitter to the next level and try again.
- Page 8 ◎ Notes of training 1. Don't leave an electronic remote training collar on your dog for more than 12 hours at a time because it may irritate the dog's neck. 2.This product is for pet training. Only by training, the pet can understand the intention of its owner.