Outbound SKIMMERPLUS SFX600 Operating Instructions Manual page 9

TM
Before assembly, take a few minutes to identify and become familiar with all the parts.
WARNING:
CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Skimmer Installation
1. Set up your pool following the pool Owner's Manual instructions. Do NOT fill
water until the Filter Pump is properly installed. Locate the Skimmer Opening
on the pool wall.
Skimmer Opening
Pool Inlet
3. Turn counter-clockwise to remove the Skimmer Seal Ring
the Skimmer Gasket Rubber Seal
Return Fitting Installation
5. Assemble the Return Fitting
o
Inside Pool Wall
. Make sure
d
is in the correct position.
h
The protruding edge of the
Skimmer Canister
9
in-between the two keys of
the Gasket .
h
No gap here
as indicated below.
Make sure the Hose Clamps
seal tightly over both the Return
Hose and O-Rings
e
ASSEMBLY INSTRUCTIONS
2. Slide open the Top Cover
4. Insert the threaded part of the Skimmer Canister
Opening, and then secure with the Skimmer Seal Ring
fits
Inside Pool Wall
6. Now the Pump should be installed outside the pool wall as below.
w
.
q
To optimise water circulation,
twist the RF Diverter
that it faces up and away
from the Skimmer Opening.
and take out the parts inside.
5
through the Skimmer
9
d
Make sure that the pool liner is
placed tight on the Gasket
and is NOT trapped in the threads;
otherwise leaks may occur.
Outside Pool Wall
Inside Pool Wall
so
p
5
.
h
thread slots
9