Outbound SKIMMERPLUS SFX600 Operating Instructions Manual page 10

ASSEMBLY INSTRUCTIONS
Pump Installation
7. From inside the Skimmer Canister
pivot slots, one after another. The Weir should now stand upright but not stick.
Push-in
9. You can now fill the pool with water up to between the MIN and MAX markings on the inside of Skimmer Seal Ring
The water level should be
between the min and max
markers located inside the
Skimmer Seal Ring.
Max. Level
Min. Level
USE OF PUMP
1. Plug the Power Cord Set
j
2. From inside the pool, check if the water flow from the RF Diverter
If not, or if you feel a reduction in flow, clean or replace the Filter Cartridge
as Problem 2 of TROUBLESHOOTING GUIDE (p. 17).
3. To turn the Pump off, unplug from the power outlet.
4. VERY IMPORTANT: Check and adjust the pH and chlorine levels daily. THE FILTER PUMP ALONE WILL NOT PREVENT ALGAE FROM GROWING
IN THE POOL WATER; THIS CAN ONLY BE DONE BY MAINTAINING PROPER CHLORINE AND pH LEVELS AT ALL TIMES. For details, see
POOL WATER CARE (p. 12).
10
, snap the pins of the Weir
9 8
Weir installation
finished.
Inside Pool Wall
to a properly grounded receptacle.
8. Slide the Top Cover
into the
is correct. It should feel like a solid stream of water returning to the pool.
p
. For details, see FILTER CARTRIDGE USE & CARE (p. 11) as well
7
closed onto the Skimmer Canister
5
9
Inside Pool Wall
.
d
TM
.
9
5