Outbound SKIMMERPLUS SFX600 Operating Instructions Manual page 14

PUMP SERVICING INSTRUCTIONS
5. Slowly take out the Motor Assembly
Nozzle or Canister Gasket
2 4
STEP 2: Rotor Inspection/Replacement
The Pump consists of a Rotor Assembly
3
in place between the Volute Cover
1. Loosen the Volute Cover Lock Nut
2. Pull the Rotor Assembly out from the Pump Body
k
Inspect the Rotor (see image below) to make sure that the Rotor Shaft, Magnet Axle, Impeller and other parts are intact.
3. Once the inspection or replacement is done, carefully insert the Rotor Assembly
down in place.
4. Align the Volute Cover with the top Shaft End Cap, then tighten with the Volute Cover Lock Nut
l
5. Attach the Rubber Nozzle to the outlet of the Pump Body
2
2
SFX600/SFX1000
14
. Be careful not to lose the Rubber
3
.
and its related parts. If the Rotor and/or its parts is/are broken, or the Rotor, even in perfect condition, is not seated
k
and Pump Body , the Pump will not function properly.
l x
or Bolts (depends on the pump model), and remove the Volute Cover
; z
.
x
.
x
Rotor Assembly Parts
31
4
2
back into the Pump Body
k x
or Bolts
;
Shaft End Cap
Washer
Impeller
Magnet Axle
Rotor Shaft
(This shaft should go through
2
all the parts and into both
Shaft End Caps)
Washer
Shaft End Cap
You may need to reach inside the
Canister to free the Pump Motor.
3
.
l
. The force of the magnet will pull the Rotor
(depends on the pump model).
z
SFX1500
TM
31