Programming Cable Id Lock; Programming Macro Keys - Universal Electronics Atlas ATLAS OCAP 5-Device User Manual

PROGRAMMING CABLE ID LOCK

The Atlas OCAP 5-Device Remote Control with Learning
is locked at the factory to operate your cable provider's
set top box. However, if you have another brand or
model of cable converter or satellite service that you
would like to control, then you'll need to perform the
following steps to unlock the ID Lock, enter a new
manufacturer's code, and lock the ID Lock again.
1. Turn on the cable converter.
On the remote control, press CBL once; it will
2.
blink once. Then press and hold SETUP until
the CBL key blinks twice.
Enter 9 8 2. The CBL key will blink four
3.
times, indicating ID Lock is unlocked.
4. Perform the instructions under
"Programming Device Control" on page 10 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the cable ID Lock.
On the remote control, press CBL once; it will
5.
blink once. Then press and hold SETUP until
the CBL key blinks twice.
Enter 9 8 2. The CBL key will blink twice,
6.
indicating ID Lock is again locked.

PROGRAMMING MACRO KEYS

The Atlas OCAP 5-Device Remote Control with Learning
includes two macro keys (located directly below the
MUTE and LAST keys). Macro keys allow you to set up key
macros to activate certain keys in a specific order. For
example, you can set up a key macro to change the
channels on your TV, raise or lower the volume, and
start recording on your VCR, all with the touch of one
key. If you want to change the macros stored in a
previously-programmed macro key, you'll need to clear
the key first (see "Clearing a Macro Key" on page 21).
www.urcsupport.com/atlasocap
20