Machine Cleaning; Waste Water Tank Full - Numatic TGB 8572/200T Original Instructions Manual

!
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY
MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY.
REMOVE THE KEY PRIOR TO ANY MAINTENANCE OPERATION.
Located under the top tank at the front of the machine is a clean
water filter.
Note: Make sure the top tank is empty before lifting.
After use, empty waste water tank
A
using emptying hose and flush out
with clean water.
Next remove floor tool vacuum hose
B
and flush out with clean water.
A
Next empty clean water tank, using
C
emptying hose and again flush out
with clean water.
Whilst pressing in the top tank hood
toggles, remove the hood.
The hood also has a sealing-rubber which
should be examined at every clean-down.
Rinse using clean water, avoiding the
vac filter.
Located in your waste water (top) tank is a
full tank switch, this stops the vacuum from
working once the waste water reaches its
maximum limit.
Sometimes the switch gets clogged and
blocked, clean to ensure correct operation.
Also please ensure float pad is clean and in
correct position.
IMPORTANT
Remove vac filter and clean if required
(keep dry).
Never use the machine without the
recommended filter as it may cause
damage to the machine.
Remove debris basket filter and rinse
using clean water, and refit.
IMPORTANT If the debris basket is
allowed to become clogged, vacuum
performance can deteriorate.
Regular Maintenance
B
C
T 01460 68600
!
19