Access Control Settings; Door Lock Settings; Wiegand Settings - TKH Skilleye SEP-FRTMP01 User Manual

Temperature Measurement & Face Recognition Terminal User Manual
Fill out the relevant information and click "Entry" to add this face picture.
5

Access Control Settings

5.1 Door Lock Settings

Click Config→Access Control→Door Lock to go to the following interface. After the access
control device is connected to the terminal, you can set unlocking mode in this interface.
Unlocking Mode: three options--face recognition, normal temperature and mask. Please check
as needed.
Face Recognition: if the capture face picture is successfully matched, the door can be unlocked.
Normal Temperature: if the temperature of the person measured is normal, the door will be
unlocked.
Mask: if there is a mask on the face of the detected person, the door will be unlocked.
Unlocking Delay Time: Set the door unlocking delay time. The time range is from 0 to 10
seconds. For example, "By Face Recognition" is selected and the delay time is set to "2"
seconds; the door will be opened 2 seconds later after face recognition.
Unlocking Duration: If the door has been unlocked for a period that exceeds the duration, the
door will be automatically locked. The time range is from 0 to 10 seconds. For example, "By
Face Recognition" is selected and the duration is set to "3" seconds; the unlocking door will be
automatically locked 3 seconds later.

5.2 Wiegand Settings

Click Config→Access Control→Wiegand Config to go to the following interface.
19