Table of Contents
Advertisement
Installation
System Installer must adhere to Article 820-40 of the NEC that provides guidelines for proper grounding and
specifies that the cable ground shall be connected to the grounding system of the building, as close to the point
of cable entry as possible.
System/Site Requirements
1. It is highly recommended that the hardware be housed /placed in a well-ventilated area with temperatures not to
exceed between 0C to 45C.
2. RF Antennas must be properly installed and verified for proper signal reception and signal levels.
3. IGMP Capable (and enabled) Network switches ARE REQUIRED for IP Output systems. It is highly
recommended that a professional IT contractor or staff member properly sets up and configures the IGMP Switch.
Hardware Installations and Connections
It is highly recommended that quality cables and connectors be used for all video and audio source connections.
1. The unit is designed to be rack mounted in a standard EIA 19" rack.
2. Connect the video source to the unit's Tuner Input jack. Use a quality 75Ω coaxial cable with "F" connectors to
ensure the quality.
Repeat this step for each video source connection required.
Be sure the connections for each source are consistent with the unit's inputs (Input 1...Input 8).
3. Connect an ethernet cable from IP OUT Port on the destination.
4. Connect an ethernet cable from UTILITY Port on the DT-ATSC-IP-8 to a PC/MAC for setting.
5. Connect the included power cord to the unit's POWER plug.
6. Connect the power cord to an appropriately rated AC power outlet.
Reset to Default
1.
With the unit's power cord disconnected, press and hold reset button.
2.
Reconnect power to the unit while holding the reset button, the PWR LED will
automatically flash on and off once, then release the reset button to reset to default.
Warning!
"Reset to Default" will automatically reset all saved settings back to factory default settings.
All saved settings will be lost!
NACE:
610-429-1511
| sales@datatronix.biz | www.datatronix.biz | | DT-ATSC-IP-8 Manual v1.0
Reset
Page 6
Advertisement
Table of Contents
