Download Print this page

BUSCH H0 5491 Assembly Instructions Manual

Crossing blinkers

Available languages

Download this manual

M o n t a g e a n l e i t u n g f ü r B a u s a t z

W A R N B L I N K A N L A G E H 0 5 4 9 1

Ω

Page 1 M o n t a g e a n l e i t u n g f ü r B a u s a t z W A R N B L I N K A N L A G E H 0 5 4 9 1 Ω...
Page 2 ð ð ð ð ð ð ð ð ð ð ð...
Page 5 (14 - 16 V) and is in compliance with EN 60 742. row top, a fine rope of soldering ore, in- Not siutable for children under 8 years of age. stant glue (Busch 7597) and white enamel Please retain these instructions. paint.
Page 6 Safety advices: LEDs 1. Provide sufficient air ventilation while working with glues -caution- glue may be hazardous to health! 2. All electronic parts contained in this kit marking must be connected to low tensions only grey red (max. 16 volts). 3.
Page 7 (13) in same manner before A more comfortable and convenient putting elkos in position. These parts are method is achieved by use of Busch IR- units in connection with a timer (Busch also marked appropriately and the shorter #5961). When IR-beam is interrupted by a wire is your negative pole.
Page 8 Refer to pic. 6 for proper installation of ouflaged by use of irish moss or other ma- blinkers and timer (Busch # 5963). terials to keep out of sight. An IR-unit consists of a transmitter emit- Convenience is gained by the latter method ting infra-red rays of light and a receiver.