Operation - Honeywell Energy Smart CoolTouch HZ-7200 Series Manual

OPERATION

EnergySmart® Cool Touch Heaters require no assembly. Never
leave an operating unit unattended.
Plug the heater into an electrical wall outlet.
Models HZ-7200 & HZ-8000 Series – EnergySmart®
Cool Touch Heater Operation
Turn the heater on by pressing the Power Button ( ). The
Power Indicator Light will illuminate. Fig. 1
To save up to 35% in energy bills, turn the Power Knob to
your Desired Temperature. There are four (4) comfort settings
of 65°F (18°C), 70°F (21°C), 75°F (24°C) and 80°F (27°C).
The EnergySmart® thermostat will automatically select the
appropriate power level to best accommodate your Desired
Temperature. As the air temperature (Current Temperature)
in the room approaches the Desired Temperature, the heater
will automatically lower the power consumption and provide
consistent warmth without wasting energy.
Illuminated LED lights will indicate the Current Room Temperature.
NOTE: The LOW setting is designed to operate only if the
temperature is below 55°F (12°C). If the room temperature is
above 55°F (12°C), the heater will remain OFF until the
temperature drops below this level. If you want the heater to
operate when the room temperature is above 55°F (12°C),
move the Power Knob to a higher setting.
To override the EnergySmart® feature and produce maximum
heat, turn the Power Knob clockwise to HIGH. The will run the
heater at constant 1500 watts.
To turn on the oscillation feature, press the ( ) button once. To turn it off, press the ( ) button once more. Please note, the
oscillation function will stop when the Energy Smart™ mode has reached the desired temperature and the heater is no longer
blowing warm air. It will start back up when the heater starts blowing warm air again.
Press the Power Button ( ) and unplug the heater when you are finished using it and the Power Indicator Light will go out.
Model HZ-7300 Series – Deluxe EnergySmart® Cool Touch Heater Operation
Turn heater on by pressing Power Button ( ) button.
The heater will default to the Constant HI mode and the
Current Temp Indicator will display the current room
temperature. Fig 2.
The Energy Usage Indicator will display the power
consumption used by the heater.
• If HIGH, the heater is drawing 1500 watts to quickly warm
the room
• If LOW, the heater is drawing 900 watts to slowly warm the
room or maintain the temperature
• If STAND BY, the heater is drawing no power as the room has
reached the Desired Temperature. At this point, the heater
is most efficient and is drawing only a few watts of energy
while in STAND BY mode.
Fig. 1
Energy Smart
Power Knob
Power
Button
HZ-7200
Energy Smart
Power Knob
Power
Button
HZ-8000
Fig. 2
Energy Usage
Indicator
Constant and
EnergySmart™
Thermostat
Modes
SET Temp
Button
Oscillation
Button
Power Button
HZ-7300
Oscillation
Button
l
®
Oscillation
Button
®
® /MD
®/MD
3