Using The Device For The First Time; Assembling The Device; Cleaning And Sterilising The Device; Directions For Use - Microlife BC 100 Soft Manual

3. Using the Device for the First Time

NOTE:
Check that the packaging of the device has not been tampered
with and make sure that all components are present. Before
use, ensure that there is no visible damage to the device or
accessories and that all packaging material has been removed.
If you have any doubts, do not use the device and contact your
retailer or the specified Customer Services address.

Assembling the device

Once the device has been removed from the packaging, check the
plastic containers in particular for cracks.
1. Screw the pump attachment 1 onto the bottle 5. Ensure the
pump attachment is firmly secured so that no liquid can escape
(see short instruction).
2. Attach the handle for the manual pump including the silicone
membrane by pressing the silicone membrane firmly onto the
pump attachment until it clicks into place (see short instructions).

Cleaning and sterilising the device

WARNING
Clean and sterilise the separate parts of the device that
come into direct contact with the breast milk individually
before first use and any further use.
To sterilise the device correctly, proceed as follows:
1. Unscrew the pump attachment 1 from the bottle 5.
2. Remove the silicone membrane 2 and silicone valve 3 from
the pump attachment.
3. Sterilise the bottle and pump attachment (with silicone
membrane and silicone valve) for five minutes in boiling water or
using a steam steriliser. Do not use the device until all individual
parts are completely dry. Do not use any antibacterial cleaning
products, since these may damage the plastic on the device.
4

4. Directions for Use

Tips to ensure a better milk flow
Choose a time and location to use the device where you can
relax.
Having your child nearby or looking at a picture of your child can
have a positive effect on the milk flow.
If feeding your child using one breast, use the device on the
other breast at the same time.
Warmth and relaxation encourage milk flow. Use the device
after having a shower or bath.
If your breasts are swollen or sore, place a warm towel on them
for a few minutes. This will improve the milk flow.
If the milk does not start to flow from your breasts immediately,
try to relax and then try again a few minutes later.
If the device still does not extract any milk from your breasts
after five minutes, stop using it and try again later.
If you experience any sharp pains when using the device,
consult a doctor.

Operating the device

1. Before using the device, wash your hands and breasts thoroughly.
2. Sit with your upper body lent forwards slightly. You can support
your back better by using a pillow.
3. Then place the breast shield with silicone cushion 4 gently on
the breast. Make sure that the nipple is completely enclosed
and there are no air pockets. To ensure proper function, the
breast shield must be drawn firmly onto the breast.
4. You can vary the pump intensity on the manual pump attach-
ment 1 by selecting between the MIN/MAX markings that can
be seen. We recommend starting in the MIN position.
NOTE:
See the pictures at the start of the instruction manual for
more information.

Storing the breast milk

Expressed milk can be stored in the fridge or freezer for a certain
period of time.
When storing breast milk, ensure that the device and the bottles
are disinfected before usage. Only store breast milk in disin-
fected containers.
Store breast milk in the fridge or freezer immediately after
expressing. Do not leave breast milk out at room temperature.
If storing breast milk in the freezer, it is recommended that you
mark the bottle with the date of expressing.