Haier QPHR50 Owner’s Manual And Installation Instruction page 8

USING THE DEHUMIDIFIER
Removing Collected Water (Continued)
To Install Hose: Push in hose and gently pull to make
sure it is secure. Should not be able to be removed. You
should hear a "click" that lets you know the hose is inserted
correctly.
To Release Hose: Press the blue button on top of the
connector attached to the dehumidifier and pull the hose
out to remove.
Water Level
The dehumidifier will turn off automatically when the bucket is
full, or when the bucket is removed or not replaced in the proper
position.
Bucket Operation
DO NOT remove the foam piece in the bucket assembly.
If removed the Dehumidifier will not work properly.
When the coil is defrosted, the compressor or fan will
automatically restart and dehumidifying will resume.
8
Insert
Press
Pull
NOTE: DO NOT kink or crimp hose, as it can block water flow.
The bucket must be replaced in the proper position for the
dehumidifier to work. The light will be on and the dehumidifier
will not run if the bucket is not in the proper position.
49-5000429 Rev. 2