Removing The Blower From The Crate - Toro Pro Force 44547 Operator's Manual

1
Removing the Blower from
the Crate
No Parts Required
Procedure
Important:
Install the jack stand to stabilize the
blower before the blower frame is unbolted from
the shipping crate or the crate is removed.
1. Remove the top of the crate
1. Top of crate
2. End of crate
2. Remove the end of the crate which is toward the
top of the machine
3. Remove the board that is under the blower
housing (Figure 3).
4. Secure a strap to the top end assembly and lift
the pallet until the crate and blower is standing
up vertically (Figure
(Figure 3).
Figure 3
3. Top of machine
4. Board under blower
housing
(Figure 3).
4).
1. Lift strap
5. Remove the snapper pin securing the jack-stand
tube to the storage tube
jack assembly from the storage position.
g021672
1. Snapper pin
6. Remove the strap from the pallet and attach it to
the lift loop on the blower
6
Figure 4
2. Top end assembly
(Figure 5). Remove the
Figure 5
2. Jack-stand tube
(Figure 6).
g021673
g021674