Table of Contents
Advertisement
Figure 4 W-AP275 Rear View
USB Console Port
The USB Micro-B console port allows you to connect the AP to a terminal or a laptop for direct local
management. Use the included USB console cable to connect the AP. You can download the necessary driver for
USB-UART adapter from download.dell-pcw.com under the Tools & Resources tab.
Use the following setting to access the terminal:
Table 3 Console Settings
Baud Rate
9600
Ethernet Ports
The W-AP270 Series access point is equipped with two 10/100/1000Base-T (RJ-45) Gigabit Ethernet ports (WAN
and LAN port) for wired network connectivity. The WAN port supports 802.3at Power over Ethernet (PoE),
accepting 48 VDC (nominal) as a standard defined Powered Device (PD) from a Power Sourcing Equipment
(PSE) such as a PoE midspan injector.
These ports have RJ-45 female connectors with the pin-outs shown in
Figure 5 Gigabit Ethernet port Pin-Out
Reset Button
The reset button can be used to return the AP to factory default settings. To reset the AP:
Dell Networking W-AP270 Series Outdoor Access Point | Installation Guide
Data Bits
Parity
Stop Bits
8
None
1
Grounding Point
USB Console Port and Reset button
AC Power Interface
LAN Port
WAN Port
Flow Control
None
Figure
5.
5
Advertisement
Table of Contents
