Specifications; Led Indications - Velbus VMB1BLS Short Manual

a

SPECIFICATIONS

• relay contact:
- 230 V AC/ 16 A max.
- 30 V DC / 12 A max.
• supply voltage: 12..18 V DC
• power consumption: max. 100 mA
• dimensions: 72 x 59 x 24 mm
CHARACTERISTICS
• controlled by Velbus or by directly
connected push buttons
• programmable switch-off time per channel
• feedback to the input modules
• LED indications for
- up and down working modes
- supply voltage
- error messages
• encapsulated for mounting in e.g.
shutter casings
• 250 possible addresses
CONTROL
Two buttons:
• short press on ↑ or ↓: shutter up/down until end or until
opposite
direction pressed
• continually pressing ↑ or ↓: shutter up/down until button
released
One button: same principle as two buttons. After each standstill,
the motor direction is reversed. Other actions for use in a Velbus
system can be programmed using the Velbuslink* software.
For general information about the installation and
configuration of Velbus, please consult the
Installation Guide and other documentation on
www.velbus.eu.
• LED PS (power supply) ⑫:

LED INDICATIONS

- continuously on: power supply OK
• LED up ⑬: flashes while shutter is going up
- off: power supply not OK
• LED down ⑭: flashes while shutter is going down
• In case of error, LEDs up ⑬
and down ⑭ will simultaneously flash as follows:
- 2 flashes, break, 2 flashes, etc.: communication error
(only if connected to Velbus data bus and address ≠ FF)
- 3 flashes, break, 3 flashes, etc.: power supply voltage too low
- 4 flashes, break, 4 flashes, etc.: power supply voltage too high
8
www.velbus.eu