Search Hold Feature; Data Skip; Frequency Skip - Uniden UBCT8 Owner's Manual

• While Trunking is operating in scan mode, press
Search mode and ID Scan mode.

Search Hold Feature

1. Press HOLD/RESUME
step, use the or
2. Press HOLD/RESUME

Data Skip

A scanner will normally stop on any transmission it
receives. This means the UBCT8 will occasionally stop
on data signals and unmodulated transmissions. You
can automatically skip many of these types of
transmissions during search.
1. To activate the Data Skip feature, press
appears on the display.
2. To deactivate the Data Skip feature, press
When Data Skip is active, your scanner may pause momentarily on an unwanted signal
but will resume searching in two or three seconds. The Data Skip feature is active as
well as Scan mode and Service Search mode. Data Skip does not function during
Service Scanning band (for
mode.

Frequency Skip

If a particular frequency continues to interrupt search scanning, it is possible to set the
scanner to skip the frequency.
To skip over a frequency, press
when in Search Hold mode.
Note: You can program up to 100 skip frequencies.
The 101st skip frequency entered causes the first skipped frequency to unlock.
To restore a Locked out/Skipped channel.
1. Select the desired frequency by using the
2. Press L/O , and then press
To restore all skipped frequencies, press and hold
at anytime to stop the search. To move up or down 1 frequency
key.
to resume searching.
DATA in Scan or Search mode. "
DATA again. "
AM or Wide FM Transmission
L/O when stopping on the frequency you want to skip or
or
HOLD/RESUME .
L/O
SRCH and it will move to ID
SCAN
DATA
DATA " disappears.
), Priority Scan, and Trunking
key in Search Hold mode.
for 2 seconds in Search Hold mode.
"