Hold/Resume; Channel Lockout; Restoring A Locked-Out Channel In Hold Mode - Uniden UBCT8 Owner's Manual

Hold/Resume

If you want to stop on a channel during scanning, press
HOLD/RESUME.
If you want to resume scanning, press
Direct channel access:
There are several ways to access a specific channel quickly.
1. Press HOLD/RESUME.
2. Using the keypad, enter the channel number.
3. Press HOLD/RESUME
Note: You can also use the SCAN,
pressing HOLD/RESUME.

Channel Lockout

You can lockout any channel so it is not checked during normal scanning. You can also
restore the channel to scanning when you wish.
Lockout in Hold Mode
1. Press HOLD/RESUME
HOLD/RESUME.
––– OR –––
1. Press HOLD/RESUME
or key.
2. Press L/O to lockout the channel.
"L/O" appears on the display.
Lockout in Scanning Mode
If the scanner keeps stopping on a particular channel due to noise or frequent transmissions,
you may want to keep that channel from scanning.
1. Wait until the scanner stops on the channel.
2. Then press L/O.
3. The scanner immediately resumes scanning because the locked out channel is no
longer in the scanning sequence.
Lockout Tips Write down your locked-out channels and put in a convenient place in
case you need to restore them.

Restoring a Locked-out Channel in Hold Mode

1. Press HOLD/RESUME
keypad, the or key, then press
2. Press L/O to unlock the channel. The "
HOLD/RESUME.
again.
or key instead of
and enter the channel number by using the keypad, then press
and select the channel by using the
and select the channel number you want to restore by using the
HOLD/RESUME.
L/O " disappears.
SCAN
SCAN
SCAN
SCAN