Use the included connection cable to connect your
scanner to another UBCD396T scanner or your
personal computer.
Settings
PC Control
Lets you set the baud rate your scanner
PC Control
uses to communicate with a personal computer.
•
The baud rate is not set.
Off
•
The baud rate is set to 9600 bps.
9600 bps
•
The baud rate is set to 19,200 bps.
19200 bps
•
The baud rate is set to 38,400 bps.
38400 bps
•
The baud rate is set to 57,600 bps.
57600 bps
•
The baud rate is set to 115,200 bps.
115200 bps
Using the Cloning Options
Lets you set your scanner as a master (source) or
slave (recipient), letting you transfer programming to
or from another UBCD396T scanner. See "Wired
Cloning" on Page 53 (below) and "On-Air Cloning" on
Page 54.
Wired Cloning
Xfer Information
Wired Clone
•
Sets the scanner to be the source
Master
scanner.
•
Sets the scanner to be the recipient
Slave
scanner.
To clone (copy) data directly from one UBCD396T
scanner to another UBCD396T scanner, you must
first connect the scanners to each other using the
included connection cables and a DB9 null modem
adaptor and DB9 gender changer (neither
included), available at most computer stores. Then
you must set one scanner as the source and the
other as the destination.
Plug the smaller end of each of the included
connection cables into
each scanner. Then connect the other end of the
cables together using the null modem connector
and gender changer.
53
Remote
on the right side of
Other Settings