Removing The Display Sticker; Using Ac Power - Uniden UBCD396T Owner's Manual

If an AC adaptor is connected to the scanner, the
scanner checks the condition of the installed batteries.
If the scanner is turned off and the batteries require a
full charge,
Pre-Charging
Then,
Normal Charging
are recharged. When the batteries are fully charged,
appears.
Charge Complete
If no batteries are installed in the scanner,
appears. If there is a problem with the
Battery
installed batteries,
Battery Error
installed batteries are Ni-MH
ALKALINE/Ni-MH is set to
appears and the scanner does not charge the
batteries.

Removing the Display Sticker

Before you use the scanner, remove the protective
plastic sticker over the display.

Using AC Power

You can power the scanner using the supplied 6V,
800 mA AC adaptor.
To use the scanner on
AC power, plug the
adaptor into 6V 800 mA
on the right side of the
scanner, then plug the
AC adaptor into a
standard AC outlet.
If rechargeable batteries are installed and
Ni-MH is set to NI-MH , the adaptor powers the
scanner and recharges the installed batteries at the
same time.
WARNING!
To prevent damage to Ni-MH batteries, never
charge them in an area where the temperature is
above 113°F (45°C) or below 32°F (0°C).
Setting Up Your Scanner
appears on the display.
appears as the batteries
No
appears. If the
batteries but
ALKALINE ,
Charge Off
ALKALINE/
30