Bosch Professional LR 6 Original Instructions Manual page 16

16 | English
Laser receiver
Protection rating
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct sun-
light).
B) X: Maximum working range for operation with laser receiver according to the operating instruc-
tions for the Bosch line laser that is used
C) Dependent on the distance between the laser receiver and the line laser
D) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
For clear identification of your laser receiver, see the serial number (13) on the type plate.
Noise Information
Typically the A-weighted sound pressure level of the audio signal is 80 dB(A)
at 1 m away.
Do not hold the laser receiver close to your ear.
Assembly
Inserting/Changing the Batteries
Alkali-manganese batteries are recommended for the laser receiver.
Pull the locking mechanism (15) of the battery compartment cover outwards and fold
open the battery compartment cover (14). Insert the batteries.
When doing so, ensure that the polarity is correct and corresponds to the diagram on the
battery compartment cover.
When the batteries are weak, the status indicator (3) will begin to flash. It is still possible
to work for about two hours with the laser receiver.
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
Take the batteries out of the laser receiver when you are not using it for a pro-
u
longed period of time. The batteries can corrode and self-discharge during pro-
longed storage in the laser receiver.
Operation
Starting operation
Protect the laser receiver against moisture and direct sunlight.
u
1 609 92A 4HV | (19.05.2020)
IP 54 (dust and splash-proof)
Bosch Power Tools
LR 6