Uniden BC60XLT Operating Manual page 26

CONDITION
Scan doesn't stop.
Scan doesn't start.
Keypad won't work.
If you still cannot get satisfactory results and want additional
information, or to return the unit for service, please call or write
the Uniden Parts and Service Division. The address and
phone number are listed in the Warranty (at the end of this
manual).
SUGGESTION
Adjust the Squelch setting. It
may be too high.
Check the antenna connection.
Make sure the antenna is in a
vertical position.
Reception may be poor. See
above for suggestions.
It is possible that none of the
programmed frequencies are
active at the time.
Make sure there are some
programmed channels.
The scanner may be in Manual
mode. Press
scanning.
The scanner may be stopped on
a weather frequency. Press
to begin scanning.
Adjust the Squelch setting. It
may be too low.
All the channels may be locked
out. Turn off Lockout for the
channels you want to scan.
Check the Keylock. Make sure
Keylock is off before
programming or locking out
channels.
23
S
to begin
S