Cables - Aerotech AUTOMATION1-HyperWire Hardware Manual

HyperWire Card Hardware Manual

1.3. Cables

The cables are SFP+ active optical cables. The are designed for use in 10-Gigabit Ethernet links.
Table 1-2: HyperWire Cable Part Numbers
Part Number
HYPERWIRE-AO10-5
HYPERWIRE-AO10-10
HYPERWIRE-AO10-30
HYPERWIRE-AO10-50
HYPERWIRE-AO10-200
The connector module latches into the connector housing. Release the latch by pulling on the plastic pull tab
located near the connector module
Table 1-3: Cable Specifications
Specification
Cable Jacket Material
Cable Flammability Rating
Minimum
Cable Outer
Typical
Diameter
Maximum
Short Term
Tensile Load
Long Term
Crush Resistance
Impact Resistance
Flexing
Twist Bend
Short Term
Bend Radius
Long Term
Durability
www.aerotech.com
Description
HyperWire cable, active optical, 0.5 m
HyperWire cable, active optical, 1.0 m
HyperWire cable, active optical, 3.0 m
HyperWire cable, active optical, 5.0 m
HyperWire cable, active optical, 20.0 m
(Figure 1-5).
Figure 1-5: Cable Pull Tab
Description
PVC
Optical Fiber Nonconductive Riser (OFNR)
2.8 mm
3.0 mm
3.2 mm
200 N
100 N
10 N/mm (minimum) [FOTP-41]
0.5 N·m (minimum) [FOTP-25]
300 cycles [FOTP-104]
Exceeds FOTP-85 Fiber Optic Cable Twist Test
25 mm (minimum)
30 mm (minimum)
100 Cycle Minutes (minimum)
Chapter 1: HyperWire™ Card
13