Table Of Contents - Toro Greensmaster Flex 1820 Operator's Manual

This product complies with all relevant European
directives. For details, please see the Declaration of
Incorporation (DOI) at the back of this publication.
Introduction
This cutting unit is designed for cutting turf on greens
and small fairways of golf courses. Using this product
for purposes other than its intended use could prove
dangerous to you and bystanders.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for product safety and operation
training materials, accessory information, help finding
a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Important:
With your mobile device, you can
scan the QR code on the serial number plate (if
equipped) to access warranty, parts, and other
product information.
1. Model and serial number location
Model No.
Serial No.
© 2018-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Figure 1
Figure 1
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure 2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Contents
Safety ....................................................................... 3
General Safety ................................................... 3
Cutting Unit Safety.............................................. 3
Blade Safety ....................................................... 3
Safety and Instructional Decals .......................... 4
Setup ........................................................................ 5
Installing the Roller ............................................. 5
Preparing the Cutting Unit for Use on an
eFlex Machine ................................................ 5
Installing the Push Nut (CE Only) ........................ 6
Adjusting the Cutting Unit ................................... 6
Product Overview ..................................................... 7
Specifications .................................................... 7
Attachments/Accessories ................................... 7
Operation .................................................................. 7
Maintenance ............................................................. 8
Supporting the Cutting Unit................................. 8
Adjusting the Bedknife to Reel Contact ............... 8
Grinding the Bedknife ......................................... 9
Adjusting the Rear Roller Height ........................11
Adjusting the Height of Cut ................................11
Adjusting the Clip Setting.................................. 13
Adjusting the Cut-Off Bar .................................. 14
Servicing the Bedbar/Bedknife ......................... 14
Backlapping the Reel........................................ 17
g278385
2
Figure 2
Safety-alert symbol
Contact us at www.Toro.com.
Printed in the USA
All Rights Reserved
g000502