Product Overview; Specifications; Attachments/Accessories; Operation - Toro Greensmaster Flex 1820 Operator's Manual

Product Overview

Specifications

Tractors
Cutting width
Height-of-cut
Height-of-cut range
Reel bearings
Rollers
Bedknife
Bedknife adjustment
Grass shield
Counterweight
Net weight, 2120 (without front roller)
Net weight, 1820 (without front roller)

Attachments/Accessories

A selection of Toro approved attachments and accessories is available for use with the machine to enhance
and expand its capabilities. Contact your Authorized Service Dealer or authorized Toro distributor or go to
www.Toro.com for a list of all approved attachments and accessories.
To ensure optimum performance and continued safety certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be
dangerous, and such use could void the product warranty.

Operation

Refer to your traction unit Operator's Manual for detailed operation instructions. Before using the cutting unit
each day, adjust the bedknife; refer to
cutting a test swath before using the cutting unit on a green to ensure that the finished cut is correct.
These cutting units mount on the appropriate size Flex and eFlex Traction Units.
Flex/eFlex 1820—46 cm (18 inches), Flex/eFlex 2120—53 cm (21 inches)
Adjust the front roller by 2 vertical screws and held by 2 screws and nuts.
The standard bench height-of-cut range is 1.6 mm (0.062 inch) to 12.7 mm (0.500 inch).
The bench height-of-cut range with the High Height of Cut Kit installed is 7 mm (0.285 inch)
to 25 mm (1.00 inch). The effective HOC may vary depending on turf conditions, type of
bedknife, rollers, and attachments installed.
There are 2 sealed stainless steel, deep-groove ball bearings.
The front roller is 6.3 cm (2.5 inches) in diameter with a variety of configurations selected by
the customer. The rear roller is a 5.1 cm (2 inch) diameter aluminum full roller.
This machine comes standard with an EdgeMax Microcut bedknife. Optional bedknives with
a variety of configurations are available. The bedknife is fastened to a machined, cast-iron
bedbar with 13 screws (2120) or 11 screws (1820).
There is a dual-screw adjustment to the reel with detents corresponding to 0.018 mm
(0.0007 inch) bedknife movement for each indexed position.
The non-adjustable shield with adjustable cut-off bar improves grass discharge from the
reel in wet conditions.
A cast-iron weight mounted opposite to the drive line balances the cutting unit.
11–Blade—32.2 kg (71 lb); 14–Blade—33.5 kg (74 lb)
11–Blade—30.8 kg (68 lb); 14–Blade—32.2 kg (71 lb)
Adjusting the Bedknife to Reel Contact (page
7
8). Test the quality of cut by