Nilfisk-Advance SDH 5115 Instructions For Use Manual page 25

AFTER USE
1 Lift the Handle until it locks in the upright position.
2 Unplug the Power Cord and wrap it around the Handle Release Latch
and the right Operator Handle Grip.
3 Remove the pad from the machine. Clean the pad or brush and hang
it up to dry. Allow buffing pads to dry completely before using again.
Store brushes and pad holders separate from the machine. Never
store the machine with the pad holder or brush on the machine.
4 Wipe the entire machine with a clean, damp cloth.
5 Inspect the entire machine and all accessories for damage. Perform
any required maintenance or repairs before storage.
6 Store the machine in a clean, dry place with the Handle locked in the
upright position.
MAINTENANCE
C - AIR FILTER
The air filter on top of the motor must be cleaned once a week. To clean the
filter, turn the motor cover counter-clockwise and remove. Pull the filter off
and wash with warm water and allow it to dry completely before putting it back
on the machine (or blow clean with compressed air).
TECHNICAL SPECIFICATIONS (as installed and tested on the unit)
Model
Model Number
Voltage/frequency
Rated Power
Protection Class (electrical)
Protection grade (mec, moist, dust)
Sound Pressure Level (at 1.5m)
Vibration at the Hand Controls
MOTOR BRUSHES
This machine is equipped with a motor brush wear indicator light. If this light
comes on during use, contact your local Nilfisk-Advance distributor to have
the motor serviced.
CAUTION!
The motor can be severely damaged if the machine is used for
an extended period of time with the light glowing.
TROUBLESHOOTING
SWIRL MARKS
• Floor not clean.
• Area not properly swept - debris in pad or brush.
• Improper pad or brush for the job.
• Moving the machine too fast.
CIRCLES ON THE FLOOR
• Machine standing still while the brush or pad is running.
FLOOR FINISH REMOVED
• Improper pad...too aggressive.
• Moving the machine too slowly.
MACHINE WOBBLES DURING OPERATION
• Defective pad... one side is more dense than the other.
• Machine left sitting on brush or pad for extended period of time causing
bristles or pad to "take a set".
• Pad not "seated" properly into pad holder bristles.
• Warped block on brush or padholder - replace.
MACHINE DOES NOT RUN
• Check plug for proper connection - on machine and at wall outlet.
• Check building circuit breaker.
• Call for service.
V/Hz
W
dB(A)/20µPa
m/s 2
SDH 5115
56201956
230V/50/60Hz
1330
IP 30
<71.5
<2.5m/s 2
FORM NO. 56041487 / SDH 5115 - 25