Changing The Batteries - Rbrquartz Bpr|Zero; Steps - RBR quartz3 BPR zero Instrument Manual

6.2 Changing the batteries - RBRquartz BPR|zero

3
The RBRquartz BPR|zero has
However, this is intended only for purposes of sustaining the instrument during external power interruptions of a few
minutes. While the Paros will continue to run and be measured, the valve will not operate.
6.2.1

Steps:

1. Remove the battery end cap from the logger.
2. Remove the old cells from the battery end cap.
3. Install new cells with the negative terminal installed on the side with the spring. The terminals are also
labelled on the boards.
4. Reinstall the battery end cap.
RBR#0008819revA
an internal battery holder contains 8xAA batteries (any chemistry, including LTC).
(see: Opening and closing the RBRquartz BPR|zero)
– 11