Table of Contents
Advertisement
Quick Links
hatcocorp.com
Register Online!
(see page 2)
Installation and Operating Manual
WARNING
Do not operate this equipment unless you
have read and understood the contents
of this manual! Failure to follow the
instructions contained in this manual
may result in serious injury or death.
This manual contains important safety
information concerning the maintenance,
use, and operation of this product. If
you're unable to understand the contents
of this manual, please bring it to the
attention of your supervisor. Keep this
manual in a safe location for future
reference.
P/N 07.04.993.00
Flav-R 2-Go
Locker System
F2G and F2GB Series
No opere este equipo al menos que haya
leído y comprendido el contenido de este
manual! Cualquier falla en el seguimiento
de las instrucciones contenidas en
este manual puede resultar en un serio
lesión o muerte. Este manual contiene
importante información sobre seguridad
concerniente al mantenimiento, uso y
operación de este producto. Si usted
no puede entender el contenido de
este manual por favor pregunte a su
supervisor. Almacenar este manual en
una localización segura para la referencia
futura.
ADVERTENCIA
TM
AVERTISSEMENT
Ne pas utiliser cet équipement sans avoir
lu et compris le contenu de ce manuel ! Le
non-respect des instructions contenues
dans ce manuel peut entraîner de
graves blessures ou la mort. Ce manuel
contient des informations importantes
concernant l'entretien, l'utilisation et le
fonctionnement de ce produit. Si vous ne
comprenez pas le contenu de ce manuel,
veuillez le signaler à votre supérieur.
Conservez ce manuel dans un endroit
sûr pour pouvoir vous y référer plus tard.
© 2020 Hatco Corporation
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hatco Flav-R 2-Go F2G Series
Summary of Contents for Hatco Flav-R 2-Go F2G Series
- Page 1 Conservez ce manuel dans un endroit supervisor. Almacenar este manual en manual in a safe location for future sûr pour pouvoir vous y référer plus tard. una localización segura para la referencia reference. futura. P/N 07.04.993.00 © 2020 Hatco Corporation...
-
Page 2: Table Of Contents
Canada by calling 800-558-0607. Completing online warranty registration will prevent delay in Additional information can be found by visiting our web site at obtaining warranty coverage. Access the Hatco website at www.hatcocorp.com. www.hatcocorp.com, select the Support pull-down menu, and click on “Warranty”. -
Page 3: Important Safety Information
Do not operate if unit has been submerged This unit has no “user-serviceable” parts. If service or saturated with water. is required on this unit, contact an Authorized Hatco • Unit is not weatherproof. Locate unit indoors where Service Agent or contact the Hatco Service Department at ambient air temperature is a minimum of 70°F (21°C). -
Page 4: Model Description
MODEL DESCRIPTION English All Models F2G-x4 Models (Floor Mount Models) Hatco Flav-R 2-Go™ Locker Systems are designed to hold The F2G-x4 models are designed to be installed onto the floor. ® pick-up and delivery orders securely while allowing quick These models are 4 lockers high with 2 or 3 columns. -
Page 5: Model Designation
ELECTRIC SHOCK HAZARD: Plug unit into a properly Plug Configurations grounded electrical receptacle of the correct voltage, NOTE: Receptacle not supplied by Hatco. size, and plug configuration. If plug and receptacle do not match, contact a qualified electrician to determine and NOTE: The specification label is located next to the power cord. -
Page 6: Dimensions
SPECIFICATIONS English Electrical Rating Chart — Built-In Models Model Voltage Watts Amps Plug Configuration Unit Weight F2GB-3-A NEMA 5-15P 182 lbs. (83 kg) F2GB-22-A NEMA 5-15P 209 lbs. (95 kg) F2GB-32-A NEMA 5-15P 295 lbs. (134 kg) F2GB-42-A NEMA 5-15P 381 lbs. - Page 7 SPECIFICATIONS English Dimensions — Floor Mount Models Model Width (A) Depth (B) ♦ Height (C) F2G-24-A 45-3/8″ 14-5/16″ 71-1/4″ (1152 mm) (362 mm) (1809 mm) F2G-34-A 62-3/16″ 14-5/16″ 71-1/4″ (1578 mm) (362 mm) (1809 mm) F2G-24-C 45-3/8″ 22-13/16″ 71-1/4″ (1152 mm) (578 mm) (1809 mm) F2G-34-C...
- Page 8 SPECIFICATIONS English Dimensions — Built-In Models Model Width (A) Depth (B) Height (C) F2GB-3-A 60-15/16″ 14-11/16″ 20″ (1548 mm) (372 mm) (507 mm) F2GB-22-A 44-1/8″ 14-11/16″ 34-13/16″ (1121 mm) (372 mm) (883 mm) F2GB-32-A 60-15/16″ 14-11/16″ 34-13/16″ (1548 mm) (372 mm) (883 mm) F2GB-42-A 77-3/4″...
-
Page 9: Installation
CAUTION! Stop! Do not attempt to use a damaged unit. Contact Hatco for assistance. NOTE: If there is not access to the base on the operator side of the unit, then it must be secured to the wall on the 2. -
Page 10: Installing Built-In Models
INSTALLATION English 2. Remove the access panels on the bottom and top of each locker column on the customer side by removing the screws. Mounting 3. Lift the unit and carefully place it into the wall opening Locations cutout. This step requires two or more people, depending Access on the unit. -
Page 11: Operation
1. Move the Power I/O (on/off) switch to the O (off) position Use the following information and procedures to operate a and allow the unit to cool completely. Hatco Flav-R 2-Go™ Locker System. ® 2. Perform the “Daily Cleaning” procedure in the WARNING MAINTENANCE section of this manual. -
Page 12: Picking Up An Order
OPERATION English 4. Type the order code and touch ENTER. • If the customer’s name is not shown on the list, their order is not ready. • The order code can be up to 6 digits. • The name will appear on the customer-side screen to identify their order. -
Page 13: Open A Locker Manually
OPERATION English Open a Locker Manually Use this procedure to open a locker manually if the order wasn’t removed within 20 seconds. 1. On the Select Lockers screen, touch a locker number to open. 2. With the locker selected, touch LOCKER SETTINGS. 3. -
Page 14: Overtime Order
OPERATION English Overtime Order 5. Enter the new password and touch ENTER. When an order is in the locker past the maximum order time, • The unit will notify the operator “Password successfully the timer on the Select Lockers screen will turn red. The changed”. -
Page 15: Change The Temperature Setpoint
OPERATION English Change the Temperature Setpoint Updating the Touchscreen Controller Software 1. On the Select Lockers screen, touch for system settings. 1. Move the Power I/O (on/off) switch to the I (on) position. 2. Enter the Passcode and touch ENTER to access the System Settings screen. -
Page 16: Maintenance
Hatco equipment. This unit has no “user-serviceable” parts. If service is required on this unit, contact an Authorized Hatco Service Agent or contact the Hatco Service Department at 800-558-0607 or 414-671-6350. -
Page 17: Troubleshooting Guide
Troubleshooting Questions? If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco for assistance. To locate the nearest Service Agency, log onto the Hatco website at www.hatcocorp.com, select the Support pull- down menu, and click on “Find A Service Agent”;... -
Page 18: Options And Accessories
OPTIONS AND ACCESSORIES English Wall Mount Bracket Installation 4. Secure the unit to the wall using the appropriate fasteners through the holes in the wall bracket assembly and into the Use the following procedure to secure the top of a floor mount wall. -
Page 19: Limited Warranty
Hatco’s option, to repair or replacement Drawer Warmer Drawer Rollers and Slides using new or refurbished parts or Product by Hatco or a Hatco- Strip Heater Elements (metal sheathed) authorized service agency (other than where Buyer is located... - Page 20 Duffy’s - AIS Sauquoit 800-836-1014 J.B. Brady, Inc. Syracuse 315-422-9271 Register your unit online! See IMPORTANT OWNER INFORMATION HATCO CORPORATION section for details. P.O. Box 340500 Milwaukee, WI 53234-0500 U.S.A. 800-558-0607 414-671-6350 Enregistrez votre appareil en ligne ! support@hatcocorp.com www.hatcocorp.com Lisez la section INFORMATIONS IMPORTANTES POUR LE PROPRIETAIRE pour plus d’informations.
Need help?
Do you have a question about the Flav-R 2-Go F2G Series and is the answer not in the manual?
Questions and answers