Changing The Batteries - RBR quartz3 Q Instrument Manual

6.2 Changing the batteries

Permalink:https://docs.rbr-global.com/display/RSKDOC/Changing+the+batteries
Loggers are powered by eight AA size cells. These can be almost any chemistry with only a few restrictions depending
on the sensors ordered. Check your logger's compatibility in Ruskin to see if your instrument has a restriction.
Steps
1. Remove the battery end cap from the logger, see Opening and closing the logger.
2. Using both thumbs, press down on the "+" symbols on the battery cover and slide in the direction of the arrow. The
battery cover can then be folded up.
3. Invert the logger to allow the batteries to slide out of the battery carriage.
4. Insert fresh batteries into the battery carriage with the negative terminals pointing inwards, four (4) batteries per
channel.
5. Close the battery cover by folding down and then pressing with both thumbs on the "+" symbols and sliding in the
opposite direction of the arrow.
6. Replace the battery end cap.
RBR#0008818revA – 12