Caller Id Display; Automatic Call Blocking And Routing; Program Dial; Clearing Display - Digitone ProSeries II Call Blocker Operation Manual

Automatically blocks and routes screened calls using caller id with back lighted display

Hide thumbs

Table Of Contents

Table of Contents

To Remove the entire Call History Press and Hold the Delete Entry Button, then

Confirm Delete, you will then see "CID List Deleted" displayed, clearing all Call History.

Program Dial

BLUE

(left) Button – The Dial button lets you dial the number shown

in the display. Tap once to start the dialing process. The Program button allows you

to change the default settings of the DPCB using programming. Press and hold the

Program button or use the remote command # # or *** to enter programming.

Clearing Display – One Number - Delete Entry

BLUE

(right) Button

To delete a single number from Call History, use the Call History Up or Down

arrow keys to select the number you want to remove. Tap the Delete Entry Button

Once, "Confirm Delete?" will then show. To clear that displayed call, tap Delete Entry

Button again. This does not delete any entries you stored in caller lists.

Clearing Display – All Numbers - Delete Entry

BLUE

(right) Button

To remove the entire Call History, Press and hold the Delete Entry Button for 3

seconds, you will then see "Release Button".

"CID List Deleted" will then display,

clearing Call History items. This does not delete any entries you stored in caller lists.

Reviewing Call History

GRAY

Buttons - The left Up arrow button displays the

previous calls or Top of List. The right button Down arrow button displays the last call

or End of List. When Call History starts to fill up with calls, you can jump to the Top

of List by pressing and holding the Up arrow key or pressing and holding the Down

arrow key to go to the End of List.