Digitone Call Blocker Code List

Mode
Code or
Action
Standard
30 (default)
Mode
Business
31
Mode
Standby
32
Mode
Call Blocker Codes and Procedures
When calls come in, all phone numbers that are Invited will ring phones
throughout your home/office like normal and to the TEL phone port on the back
of the Call Blocker, except for Anonymous, Out Of Area, Private and Unknown
callers showing no phone number. These calls will be answered by the Call
Blocker for processing and by default be hung-up on unless program Code 72 is
enabled to allow these call types to ring in. Blocked callers will be immediately
answered and after eight seconds, get hung-up on.
To enable this (default) Mode, press and hold the Program Button for 3 seconds
until you see "Program Mode", then "Pick Up Phone", when the prompt for
"Enter Code" displays enter code 30, display shows function. You can use Code
76 to override the block function for Out of Area + no number call types or Code
74 to override the block function for Private + no number call types. These two
codes will allow those callers you need to hear from Out of Area (overseas) or
Private (neighbors) to ring through. You can also use Code 52 to invite up to 10
callers within a blocked area code.
If you are running a business and want to hear from Anonymous, Out Of Area,
Private and Unknown callers as well as any other type of call, you can enable
Business Mode Code 31 to allow calls through to the TEL phone port except
those you want to block. This mode also works with your phone company's
voice mail but also blocks those phone numbers you have entered into the
Blocked Callers List. Blocked callers will be immediately answered and after
eight seconds get hung-up on.
To enable this Mode, press and hold the Program Button for 3 seconds until you
see "Program Mode", then "Pick Up Phone", when the prompt for "Enter Code"
displays enter code 31, display shows function.
In Standby, the TEL phone port will be connected directly to the telephone line
and phones connected there will ring. This feature allows you to leave the Call
Blocker off whenever you like without disconnecting the device and the RED
light will blink slowly.
To enable this Mode, press and hold the Program Button for 3 seconds until you
see "Program Mode", then "Pick Up Phone", when the prompt for "Enter Code"
displays enter code 32, display shows function.
Explanation