Klarstein Skal Manual page 29

Universal 5 L beer keg
1. Before piercing the plug on the top of the keg, you must always follow the
instructions marked on the keg to eliminate the excess gas and ensure that the keg
has rested long enough to avoid foam coming out through the tap faucet.
2. Uprightly direct the piercing pin against the sealant on the upper center of the keg
(maybe you need to tear off the marking ring or change a proper sealant), press
the piercing pin/keg lifter to poke the sealant and then push the piercing pin all
immerse in the keg quickly. To assemble the tap mechanism until you hear a "Ka"
sound that will indicate the tap mechanism fixes on the beer keg.
Beer Dispensing unit
Keg seal
Beer keg
3. Open the beer cooler with 30-40 N strength and place the well-assembled keg
into the cooling cavity; Connect the CO₂ connector tube and beer outlet tube with
the keg lifter tube connector. Note: make sure all connection of tap mechanism
is well connected, and without damage. And make sure tap valve is on
close status, and the CO₂ pressure regulator knob is at "Off" status.
closed
open
Beer connector
CO₂ connector
EN
29