Commissioning - Klarstein Skal Manual

EN
26

COMMISSIONING

Installation
1. Take out the beer cooler from its package. Place the beer cooler on a steady and
horizontal surface, and make sure the beer cooler is at least 5 inches/10 cm away
from other appliances or wall on each side so as to allow correct ventilation on the
appliances to get better performance.
Handle
2. Install the tap handle connect the tap, make sure both end fit together perfectly.
3. Set the water drip tray into the notch provided.
4. Plug the beer cooler. Note: Do not connect or disconnect the electric
plug when your hands are wet. Before use it, make sure the voltage is
conformity with plug mark, and check whether the power cord is well
connected or not; if not, please don't use it, and call service center.
5. Put 800ml water into the cooling cavity or pour the water to the max mark (It can
work without water, but it can't display the best performance). Note: Make sure
the drain switch is at "Off" position, and no extra objects in the cooling
cavity
Max. mark
Drip tray
Faucet