Table of Contents
Advertisement
B. Install the battery pack
Charge the battery pack for at least 15-20 hours before plugging the
phone line into your phone.
1) Press in on the battery cover release and slide the cover down until it
comes off.
Use only the
Uniden battery
(BT-905) supplied
2) Connect the battery pack connector observing correct polarity (black and red
with your phone.
wires) to the jack inside the battery compartment.
Replacement
batteries are also
available through
Do not exert any force on this connection. It could cause damage to the
the Uniden Parts
battery or to the handset. The plastic connectors will fit together in only one
Department.
way. Once you are are certain that you have made a good connection, then
(See page 4.)
insert the battery pack into the battery compartment. Do not pinch the wires.
3) Securely close the battery compartment cover by sliding it up until it snaps
into place.
4) Place the handset on the base. Remove the beltclip, if attached, for face
up charging.
Battery use time (per charge)
From fully charged
Seven hours continuous use
Fourteen days when the handset is in the standby mode
Advertisement
Table of Contents
