Table of Contents
Advertisement
Ringer tone and volume
When the phone is in standby mode, pressing the vol
volume and tone. There are two ringer tones each with two volume levels. Continue pressing the vol
key to listen to all tone and volume levels. The phone keeps the last ringer tone and volume setting selected.
Earpiece volume
The handset earpiece volume settings (Low, Medium, High and Maximum) can only be
adjusted during a call. Press vol
When you hang up, the phone keeps the last volume setting selected.
The redial/p key redials the last number dialed. The redialed number can be up to 32 digits long.
Some telephone companies use equipment that require pulse dialing (sometimes
referred to as rotary dialing). If you need to enter tone dialing digits, you can
switch-over to tone dialing during the call. An example of this could be entering
your bank account number after you have called your bank. The digits of your bank
account can be sent using DTMF tones.
Initially make your call with the pulse dialing mode. Once your call connects, press */tone
desired number (like in example above the bank account number). These digits will be sent as tone
dialing. This special number can be stored in a memory location and used for Chain Dialing
(See page 20.) Once the call ends, the tone mode is canceled and pulse dialing mode resumes.
or
or
to select Low, Medium, High and Maximum.
key on the handset selects the handset ringer
or
The tone feature
only applies when
the dial mode is
set to pulse.
. Enter the
Advertisement
Table of Contents
