Power Cable Warning (Japanese); Contacting Juniper Networks - Juniper PTX Quick Start Manual

Optical inline amplifier

Before installing the optical ILA, read the planning instructions in the optical ILA documentation to make sure that the

site meets power, environmental, and clearance requirements for the optical ILA.

Before connecting the optical ILA to a power source, read the installation instructions in the optical ILA documentation.

If the rack or cabinet has stabilizing devices, install them in the rack before mounting or servicing the optical ILA in the

rack or cabinet.

Before installing or after removing an electrical component, always place it component-side up on a flat antistatic mat

or in an antistatic bag.

Do not work on the optical ILA or connect or disconnect cables during electrical storms.

Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces, and watches.

Metal objects heat up when connected to power and ground and can cause serious burns or become welded to the

terminals.

Power Cable Warning (Japanese)

The attached power cable is only for this product. Do not use this cable for another product.

For technical support, see:

http://www.juniper.net/support/requesting-support.html

Juniper Networks, the Juniper Networks logo, Juniper, and Junos are registered trademarks of Juniper Networks, Inc. in the

United States and other countries. All other trademarks, service marks, registered marks, or registered service marks are the

property of their respective owners. Juniper Networks assumes no responsibility for any inaccuracies in this document. Juniper