Advertisement
Quick Start Guide
PTX Optical Inline Amplifier
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 4
Step 3: Keep Going | 5
Step 1: Begin
IN THIS SECTION
Mount the Optical ILA | 2
Connect Power to the Optical ILA | 3
To install and configure a Juniper Networks Optical Inline Amplifier, you need:
Electrostatic discharge (ESD) grounding strap (not provided)
Four screws to secure the chassis and mounting brackets to the rack (not provided)
Screwdriver appropriate for the rack-mounting screws (not provided)
Two power cords with plugs appropriate for your geographical location (provided with the AC model)
Two DC power connectors (provided with the DC model)
Power cable or cables appropriate for your geographical location available to connect DC power to the optical ILA (not
provided)
RJ-45 cable and RJ-45 to DB-9 serial port adapter (provided)
Management host, such as a PC laptop, with a serial port (not provided)
Advertisement
Table of Contents
Related Manuals for Juniper PTX
Summary of Contents for Juniper PTX
- Page 1 Mount the Optical ILA | 2 Connect Power to the Optical ILA | 3 To install and configure a Juniper Networks Optical Inline Amplifier, you need: Electrostatic discharge (ESD) grounding strap (not provided) Four screws to secure the chassis and mounting brackets to the rack (not provided)
- Page 2 (Optional) Grounding cable with lug, screws, and washers (not provided) (Optional) 23-in. mounting brackets (provided) Mount the Optical ILA NOTE: Place the rack in its permanent location, allowing adequate clearance for airflow and maintenance, and secure it to the building structure. If you are mounting multiple units in the rack, mount the heaviest unit at the bottom and mount the other units from bottom to top in order of decreasing weight.
- Page 3 Connect Power to the Optical ILA The optical ILA is supplied with two factory-installed power supplies. For instructions on connecting DC power, see the installation instructions in the Optical Inline Amplifier Hardware Guide. To connect power to an optical ILA with AC power supplies: 1.
- Page 4 Step 2: Up and Running IN THIS SECTION Set Parameter Values | 4 Perform the Initial Configuration | 4 Set Parameter Values You must perform the initial configuration of the optical ILA through the console port. Before you begin, set the following parameter values from the console server or PC: Baud Rate—115200 Flow Control—None...
- Page 5 Step 3: Keep Going IN THIS SECTION Safety Warnings Summary | 5 Power Cable Warning (Japanese) | 6 Contacting Juniper Networks | 6 See the complete Optical Inline Amplifier documentation at https://www.juniper.net/documentation/en_US/release-independent/junos/information-products/pathway-pages/ptx-series/ptx-ila/index.html. Safety Warnings Summary This is a summary of safety warnings. For a complete list of warnings, including translations, see the Optical Inline Amplifier documentation at https://www.juniper.net/documentation/en_US/release-independent/junos/information-products/pathway-pages/ptx-series/ptx-ila/index.html.
- Page 6 For technical support, see: http://www.juniper.net/support/requesting-support.html Juniper Networks, the Juniper Networks logo, Juniper, and Junos are registered trademarks of Juniper Networks, Inc. in the United States and other countries. All other trademarks, service marks, registered marks, or registered service marks are the property of their respective owners.
Need help?
Do you have a question about the PTX and is the answer not in the manual?
Questions and answers