Throttle Trim; Steering Rate Adjuster (St.d/R); Charging Jack - Carson Mini Bull Instruction Manual

Throttle trim

Move the trim tab to adjust the
throttle servo (or the speed
controller) at the
neutral position.

Charging Jack

Note: ON/OFF switch should
be at „OFF" position before
charging!
ATTENTION!
Never attempt to
charge non
rechargeable
batteries!
Charging jack

Steering rate adjuster (ST.D/R)

Strokes of the steering
servo horn can be adjusted
by rotating this steering
rate adjuster (ST.D/R), in
the range from 10% to
100%.
The bigger the
percentage is, the
more sensitively
the steering servo
operates.
How to change transmitter batteries
• To remove the battery
• If the transmitter
• Also make sure the
CARSON Mini Bull 407021 + Mini Devil 407022
cover, push both of the tabs
towards the centre, and
then pull the cover. Please
be careful that batteries
may pop out when the
cover is opened.
voltage indicator
fails to register,
check the con-
tacts, especially
the negative
(-) terminals and
recheck that bat-
teries are fitted
correctly.
batteries are fully charged.
-
+
7
GB