Safety Warnings - Cisco NIM-1T Installing

Recommended Practices for Cisco 1-, 2-, and 4-port Serial NIMs
•
•
•

Safety Warnings

The following safety warning statements apply to all hardware procedures involving the Cisco 1-, 2-, and
4-Port Serial Network Interface Modules for Cisco 4400 Series ISRs for Cisco 4400 Series ISRs.
Translations of these warnings are available in the Cisco Network Modules and Interface Cards
Regulatory Compliance and Safety Information document, which ships with all individual Cisco 1-, 2-,
and 4-Port Serial Network Interface Modules for Cisco 4400 Series ISRs orders, and is also available on
Cisco.com.
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Warning This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
Warning
tub, in a wet basement, or near a swimming pool. Statement 1035
Never install telephone jacks in wet locations unless the jack is specifically designed for
Warning
wet locations. Statement 1036
Warning Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface. Statement 1037
Installing the Cisco Multiprotocol Synchronus Serial NIM
6
Installing the Cisco 1-, 2-, and 4-Port Serial Network Interface Modules for Cisco 4400 Series ISRs
Do not perform any action that creates a hazard to people or makes equipment unsafe.
Keep walk areas clear to prevent falls or damage to equipment.
Follow installation and maintenance procedures as documented by Cisco Systems, Inc.