Assembly - White's GOLDMASTER Series Owner's Manual

Assembly

Search Coil
Fiber Bolt & Thumbnut
1. Remove all parts from the shipping carton and check assembly
diagram to ensure all parts are present.
2. Install black rubber washers on fiber lower rod; attach search coil
to lower fiber rod. Use only the nonmetallic washers, fiber bolt,
and fiber thumbnut provided to secure search coil loop to the
lower fiber rod.
3. Insert lower fiber rod into center rod so that the spring buttons
line up with one of the length-adjustment holes in the center rod.
Turn the camlock to eliminate any slack.
4. Insert the center extension rod into the hand-grip section. Turn
the camlock to eliminate any slack.
5. Wind the search coil cable around the rods, first revolution over
the top of the rod, all the way to the display pod. Plug the cable
into the connector on the back of the display. When looking at the
back of the display, it is the connector on the right. Tighten the
retainer ring securely.
2
Non-metallic
Washers
Fiber Rod
Camlock
Center Rod
Search Coil
Cable