Ethernet/Date & Time - EasyIO EasyIOeu SH-SystemView7 Configuration Manual

EasyIOeu SH-SystemView7 Configuration
Ethernet/Date & time
To connect the touch panel to some device by Ethernet you need to configure the Ethernet network.
This needs to be done in the Android system settings.
Go to Settings->Ethernet, enable Ethernet and if you want to use Static IP address click on Static IP
• Set the IP Address of your SystemView7;
• Set the Subnet mask of your network (usually 255.255.255.0);
• Set the Gateway.
• Set the DNS1 and DNS2. (8.8.8.8 and 8.8.4.4 for Google DNS or set the IP of the router as
your DNS)
Don't use/enable both networks at same time, Ethernet and Wi-Fi.
To have your touch panel showing the graphics in the right time you need to make sure you have the
date and time updated.
Disable Automatic time zone and Select time zone of your country. If the touch panel is not
connected to internet disable Automatic date & time, so Set date and Set time.
9