Light Sensor; Setting Lux Treshold; Timer; Programming Timer Via Smartphone - Generac Mobile CTF10 Owner's Manual

Light Sensor

NOTE: To use this feature, the Off/Manual/Timer/Light
Sensor selector must be set to Light Sensor.
The light sensor setting automatically switches lamps
ON/OFF based on ambient lighting.
When ambient lighting drops below a user programmable
lux threshold, a delay timer starts. If, after the delay time
has expired, ambient lighting remains less than the
threshold value, the unit will automatically start.
When ambient lighting exceeds the threshold value, the
unit will shut OFF after the delay period has expired.

Setting Lux Treshold

See Figure 2-5. To set the lux threshold, use a screw
driver to turn Lux level setting (A) to the desired value.
A
B
Figure 2-5. Lighting Sensor Intensity Setting
NOTE: LED (B) communicates when ambient lighting is
less than or greater than the lux threshold. See
Light Sensor LED for more information.
L
Table 1 -
LED Status
Off. Ambient lux is greater than
Slow blinking
threshold setting.
On. Ambient lux is less than
Steady
threshold setting
Owner's Manual for CTF10 Light Tower
010136
Table 1:
ight Sensor LED
Light Sensor Status
NOTE: See Figure 2-6. When using the light sensor
setting, verify light sensor (C) is clean and exposed to
ambient light.
C
Figure 2-6. Light Sensor

Timer

NOTE: To use this feature, the Off/Manual/Timer/Light
Sensor selector must be set to Timer.
The Timer setting automatically turns lamps ON and OFF
at a scheduled time.
The timer can be programmed either via a Smartphone
or through the digital timer located on the unit control
panel.

Programming Timer via Smartphone

NOTE: Requires a smartphone equipped with Near Field
Communications (NFC) technology.
To program the timer via a smartphone, download and
install the FINDER® Toolbox Android™ app. This app is
available on Google Play™.
Once installed, follow the on screen programming
instructions.
General Information
010136
13