Table of Contents
Advertisement
5.2 Operation Steps
1. Follow the tutorial to install the board, and turn on the EVK switch
2. Click file - > connect the serial port, set the baud rate, the default baud rate is
115200bps
3. Click the receiver settings button to configure the NMEA message output. It is
recommended to configure GPGGA, GPGSV, and other messages.
Figure 5-1 UPrecise Overview
Figure 5-2 Configure Baud Rate
11
Advertisement
Table of Contents
Need help?
Do you have a question about the UB40 and is the answer not in the manual?