Profi-pumpe OASIS 200-3 Li+LED Operating Instructions Manual page 3

4 English
adjustable water lift: water lift is controlled by a variable speed valve, you can only adjusted the water lift under
mode of battery powered. (Note: greater water lift means more energy is consumed, therefore shorter operating time)
lower battery: the system is designed with battery over discharge protect. When battery voltage lowers than design, the
4th indicant light will blink every 2 seconds. Allow the system recharges the battery for at least 3 hours in direct sunlight.
5.2. model: oasis 200-3 li&led, oasis 500-3 li&led
Turn on the pump: short press the ON/OFF position to turn on the pump, the pump will run certain hours (ref to
battery status) and turn to solar mode automatically. The pump will operate automatically next day in direct sunlight.
charge the battery: press and hold on 3 seconds to Turn OFF the pump and charge the full solar energy to battery
during day time, turn on the pump when you need it (on demand).
Battery status: Green: battery is full charged. Pump will run around 6-8 hours. orange: battery is half charged.
Pump will run around 2-6 hours. red: battery needs charges. Pump will run less than 1 hour. (Note: In order to
protect battery, don't manually turn on the pump frequently)
note: The indicator light is solid when charging battery.
The solar set is operating in „solar powered" mode until you turn on the pump by pressing the „Battery" mode button.
In „Battery" mode, the LED light automatically switches on when it is dark.
5.3. model: oXYGen-3
note! The pump of the OXYGEN-3 must be placed outside the water and in a place protected from moisture.
Oxygenator only works when the solar panel is optimally aligned with the sun.
5.4. model: oslo 300 light-3
Construction of the battery and the pump housing
Lead-Acid Circuit Control
Housing
Battery board housing panel
8.2. model: oasis 200-3 li&led
Construction of the pump housing
Filter Cover
Impeller cover
Impeller
6. PerFormance oF The PumP
The performance of the pump depends on the orientation of the solar panels towards the sun and their intensity. The
max. Performance is achieved under optimum conditions. A function in the shade or under cloudy skies can not be
guaranteed. The solar pond kits are designed primarily for use in the summer months. However, the solar panel power
should be enough even on days in spring and autumn with excellent sunlight to operate. However, this can not be gua-
ranteed. For models with battery operation the function of the solar pond sets the charge state of the battery depends.
Depending on the pump version allows you to customize the delivery. If a controller is available at the pump, as in the
horizontal position is the max. achieved delivery. In a vertical position only little or no water is pumped. If the solar power
set also a remote control, the delivery rate can be controlled with it.
7. BaTTerY inFormaTion
After 12 to 18 months, you should replace the battery. For this purpose unscrew the battery cover and replace the batte-
ry with a new (replacement batteries available on request). Please note the limited implied warranty of 6 months.
important! It must be ensured that the battery cover is properly tightened and watertight.
With repeated charge and discharge cycles Lead-Acid and NiMh battery packs are less efficient (memory effect).
This effect is much less pronounced, but still present in small mass in the Li-ion batteries used.
Through very short and frequent loading operations and many other operational influences batteries can age premature-
ly strong. The batteries are therefore subject to a consumable and wearing part of a shortened warranty of 6 months.
Screw
Impeller cover
Impeller
oasis 500-3 li&led
Construction of the pump housing
Impeller cover
Impeller
If you find that the battery will be less efficient, the battery needs to be fully charged. These allow the unit for 2 to 3 days
(pump should not be connected) standing in the sun in order to allow a maximum charge the battery or use a suitable
external charger. We recommend to occasionally repeat this procedure to extend the battery life.
If after this recharging the battery still does not meet expectations, you should replace the batteries.
NOTE: The battery is supplied charged. If the state of charge, contrary to expectations, not be sufficient to
charge the batteries for at least 8 hours to allow sufficient charging of the battery (so damage the battery to
avoid overcharging, the pump must be connected).
8. WarninGS on BaTTerY
lithium ion cells and battery may get hot, explode or ignite and cause serious injury if they are expo-
sed to abusive conditions, Be sure to follow the safety warnings listed below:
l Do not install the battry backwards, so the polarity is reversed
l Do not connect the positive or/and negative terminal or/and the battery to each other with any meta object, such as wire
l Do not disassemble or modify the battery. The battery contains safety and protection devices which may cause the
battery to generate heat, explode or ignite if damaged
l Do not place the battery in or near fire, on stoves or other high temperature locations. Do not place the battery iiin
direct sunlight or use/store the battery inside cars during hot weather. Doing so may cause the battery to generate
heat, explode or ignite
l It is not advised for children to handle the battery
l When the battery is worn out, wrap the terminals with adhesive tape or similar materials before disposal
l Immediately discontinue use of the battery, if there is an unusuak smell, a change of color or shape, or if it appears
abnormal in any other way
l Do not place the battery in microwave ovens, high pressure containers or on cookware facilities
l In the event of the battery is leaking and fluid gets into your eye, do not rub the eye, rinse well with water and imme-
diately seek medical advice. If left untreated, the battery fluid could cause serious injury to the eye
9. SerVicinG
If after some time the pump starts losing power or stops working, please clean up sediment in the pump shell or filter
cribs. Kindly note the pump can be opened by pressing down at the bottom of the filter housing. To clear the impeller,
Cover
open the pump housing at the front by sliding up the front plastic cover.
The solar module should only be
cleaned with soft tissue or propriety
glass cleaning solution.
Filter Cover
9.1. The following controls should be carried out regularly:
l Cleanness of the medium (no mud, see technical data)
l Moreover, the pump should be emptied with danger of frost, be washed out with clear water and stored dry.
10. SecuriTY TiPS
l Obey absolutely valid regulations on the electrical security
l Never run pump dry
l Pumping inflammable, as well as all other aggressive liquids is prohibited
l Pay attention to the medium max. 40°C
l Any altering of the product itself or changing of the components is forbidden.
l With longer unused times, clean the pump, wash it out with clear water, dry and store it at room temperature
l Do not connect the pump to any AC voltage power directly, it's ONLY for DC Voltage power.
l Operate the pump in freshwater or saltwater only (never above 50°C), especially keep it away from flammable
liquids.
l All solar panels are very sensitive, protect it before all against external mechanical influences (shock, vibration, etc.)
The manufacturer explains:
l To take over no responsibility in the case of accidents or damages on the basis of carelessness or disregard to
the instructionsin this book.
l To reject every responsibility for the damages which originate from the improper use of the pump.
Pull off filter cover as shown Remove filter and rinse in water
Open impeller cover, then Rinse all parts thoroughly in water
impeller can be easily removed
English 5