Salamander FPS2/ELT/GG User Manual page 8

Attach Display to Stand
Loosely install ONE (H) "C" screw to the center of each display bracket.
This will act as an alignment screw for the next step.
1. Position alignment screw into the "key hole" slot as shown
and continue to hold display
2. Immediately use (2) "H" screws to affix the mounting brackets
3. Tighten the screws installed in steps above
Salamander Designs - Electric Lift & Tilt, Mobile Display Stands
1/4"
2
1
www.salamandercommercial.com
1/4"
Gap
501-631 [04.20] page 8 of 23