Unpacking The Microwave Oven; Placement; Installing The Oven - Breville BRSMB2016 Instruction Booklet

Unpacking the microwave oven

Remove the polystyrene top packing pieces and lift out the
oven.
Unpack the oven completely removing all the protective
tape, packing materials, plastic film, etc. before connecting
the oven.
Open the oven door. In the oven compartment you should
find the turntable and rotating support ring.
Unpack all these items.
Check the oven carefully, especially the door, door seals
and the locking mechanism. If any items are missing or
damaged, contact your supplying store for assistance.
If possible retain the packaging. If you dispose of the
packaging, do so having regard to recycling provisions in
your area.

Placement

Place your microwave oven on a flat, level stable work
surface at least 85 cm above floor height and away from
sources of cold, heat and moisture.
For good ventilation, the rear of the oven should be placed
against the wall, the free distance above the top should
be at least 30 cm with a gap of 7.5 cm at the left side and
open space to the right side. This oven is not suitable for
operation in a cabinet or other enclosure.
30 cm
0 cm
7.5 cm
OPEN
85 cm
Page 5

Installing the oven

Always operate your microwave oven with the turntable
assembly properly installed.
Open the door. Drop the turntable rotor gently through the
hole in the centre of the oven and locate it on the spindle
beneath.
There is a flat machined on the spindle to hold the rotor
secure during operation.
Place the support ring in the recess.
Place the turntable on the support ring with the smooth
side uppermost.
Locate the turntable on the rotor and check that it is central
to and properly supported by the ring. Refer to the drawing
below.
Close the door.
Unwrap the power cord fully. Plug the oven directly into
the wall socket.
®