Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Loos & Co LOCOLOC 5-H
Summary of Contents for Loos & Co LOCOLOC 5-H
- Page 1 Locoloc ® #5-H HYDRAULIC SWAGER Swaging Tools...
- Page 2 TO ASSEMBLE: TO INSTALL DIE SET: THE #5-H LOCOLOC HYDRAULIC Remove four screws on right side of the upper ® PRESS AND PUMP HAS BEEN and lower dies, then slide the dies out. SHIPPED IN TWO CRATES. To install, place new dies in die shoe, lining up screw holes with die shoe.
- Page 3 TO CHECK HYDRAULIC OIL LEVEL: To check hydraulic oil level, remove cap. Oil level should be approx. 2 inches below the frame. FIGURE 4 5. Loosen the 3/8” X 16” allen head bolt, this secures the ram return micro switch bracket.
- Page 4 NOTE: Dies need not to be fully closed to TO SET PRESSURE: achieve correct swage dimension. In fact, some dies are designed to maintain gap while under pressure. 5/16”, 3/8”, 7/16", and Always make sure the die set is in the die 1/2"...
- Page 5 CAUTION: TO MEASURE BREAKING STRENGTH: Always use a five to one safety factor when designing cable assemblies. When a loop or splice is properly swaged, Locoloc copper and aluminum oval sleeves ® If the strength of the cable is 2,000 lbs. are capable of supporting a greater load than (1/8"...
- Page 6 Pressure Gauge Pump Unit Foot Switch www.loosnaples.com Toll Free: 800-321-LOOS (5667)
- Page 7 www.loosnaples.com Toll Free: 800-321-LOOS (5667)
- Page 8 HOW TO VIDEO https://www.youtube.com/watch?v=0n0HDZ6yWNc 901 Industrial Boulevard Naples, Florida 34104 USA Telephone: 239-643-LOOS (5667) / 1-800-321-LOOS (5667) Fax: 239-643-4558 E-Mail: info@loosnaples.com / Website: www.loosnaples.com Specialists in Wire Rope Hardware & Tools INST-32 Rev. 9/19/2018...
Need help?
Do you have a question about the LOCOLOC 5-H and is the answer not in the manual?
Questions and answers