Table of Contents
Advertisement
LX Flarm Red Box V4.04
•
To change audio warning volume press short mode selector, each press will increase audio volume (three
levels and mute available).
To change mode of operation press MODE button for approximately 2 seconds. If the radial LED's will run from top
toward bottom means change over to NEAREST and vice versa. After each new power on, the unit will start in Nearest
3.1.1 Display settings
Using of mode selector button is possible to adjust some parameters of the display (baudrate and hierarchy). Disconnect
the unit, press mode selector and hold, power on and continue holding of mode selector for about 4 seconds.
The display parameter indication will change (see table below) after each press on mode selector for approximately 2
seconds. To change press mode short, the status will indicate circular LED's.
Parameter
LED
Twin confg.
Tx
Baudrate
Tx+Rx
Tx,Rx l
If two units will work in parallel (double seater), one unit must be PIC (front seat) and another PAX.
LX Navigation d.o.o.
Green LED
Green LED
018˚ ˚ ˚ ˚
054˚ ˚ ˚ ˚
PIC
PAX
4800 bps
9600 bps
Table of possible settings
Example (color doesn't matter)
Baudrate is factory set to 19200.
Note!
mode.
Green LED
Green LED
090˚ ˚ ˚ ˚
126˚ ˚ ˚ ˚
19200 bps
-------
4800 bps
19200 bps
Note!
Feb.2009
Green LED
Green
162 ˚ ˚ ˚ ˚
LED 198˚ ˚ ˚ ˚
38400 bps
57600 bps
6
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the LX Flarm Red Box and is the answer not in the manual?
Questions and answers
I have a FLARM with constant 51 error message. Several times I have inserted micro SD with 7.25 in root directory, red etc lights flash then it stops on Error 50 or 51. How do I recover .... I note the new 7.40 release. I fly in Australia so the data on cable cars etc is of little relevance? See pictures at https://www.weglide.org/flight/514559