Cf3 Module Signals; Adc; Audio (Analog And Pcm) - mangOH Yellow Hardware Architecture Manual

Hide thumbs Also See for Yellow:
Table of Contents

Advertisement

2.4 CF3 Module Signals

This section describes how CF3 module signals connect to the platform hardware components (described in
Hardware Component Connections on page
Important:
CF3 module signal availability depends on the module type—some modules may not implement certain
Extension signals from the CF3 specification.

2.4.1 ADC

The mangOH Yellow supports four CF3 module ADC (Analog to Digital converter) signal sources (ADC0-ADC3).
The ADC signals connect to the following sources, as shown in
ADC0—IoT Connector 0 (CN1000, slot IOT0), pin 20
ADC1—Battery Voltage Monitor (BAT_VOL_MONITOR)
ADC2—Expansion connector (CN805), pin 9
ADC3—IoT Connector 0 (CN1000, slot IOT0), pin 37 (Hardware modification required)
ADC1
ADC2_1V8
ADC2
CF3
ADC0
ADC3
Figure 2-7: ADC Configuration

2.4.2 Audio (Analog and PCM)

The mangOH Yellow supports the CF3 module PCM (digital) audio signals. The signals connect via a Mux (analog
switch) to the following sources, as shown in
3.5 mm analog audio jack (Default configuration)
IoT connector (Alternate configuration)
Rev 2 Oct.19
11).
BAT_VOL_MONITOR
Level
ADC2_3.3V
Shifter
(R608)
Note: Default configuration — Solid lines
Alternate configuration — Dashed lines
Figure
19
Figure
2-7:
Battery Voltage Monitor
(U1003)
Expansion Connector
Pin 8
ADC0 (Pin 20)
IoT Connector
ADC3 (Pin 37)
2-8:
Hardware
(CN805)
(CN601)
41113116

Advertisement

Table of Contents
loading

Table of Contents