mangOH Yellow Hardware Architecture Guide
Table 2-1: mangOH Yellow Hardware Components (Continued)
Type and
a
Designator
Description
USB-type connectors
Client USB
micro-USB
micro-USB
(CN802)
connector
Console USB
micro-USB
micro-USB
(CN800)
connector
Antennas
RF Antennas
Main (CN307)
u.FL connectors
GNSS (CN306)
Diversity (CN304)
Integrated Main
Antenna
Integrated
(ANT300)
Wi-Fi/BT
u.FL connector
Antenna (CN308)
Wi-Fi/BT / GPS
Integrated
Integrated
Antenna
(ANT301)
NFC Integrated
Antenna
Integrated
(ANT700)
Audio connectors
Audio
3.5 mm
(CN701)
connector
Integrated
Microphone
SPK0838HT4H-
(U704)
B digital
microphone
Rev 2 Oct.19
Signals / Pins
USB
•
(Pins: 12, 13, 16)
Power (if selected)
•
UART2 (Pins: 96–99)
•
Power (if selected)
•
CF3 RF
(Pins: 49 (Main), 38 (GNSS),
31 (Diversity))
Wi-Fi+BT module RF
Wi-Fi+BT module RF
•
CF3 Pin 38 (GNSS)
•
Connects to NFC RFID
Transponder (U700) pins
1 (LA) and 8 (LB)
CF3 digital audio signals
(Pins: 30–33)
12
Notes
Purpose:
Direct connection to CF3 USB
•
Power supply—Provides power when selected by
•
the Power Supply Selection Jumper (CN801). See
mangOH Yellow User Guide for details.
For details, see
USB 2.0 on page
Purpose:Console— Connects to CF3 module
•
console
Power supply—Provides power when selected by
•
the Power Supply Selection Jumper (CN801) if
hardware change (register R809 pop/R800 depop)
has been performed. See mangOH Yellow User
Guide for details.
For details, see
UART2 on page
For details, see
RF on page
Note:
Integrated antenna is for Main only. ANT301 can
be used for GNSS. No integrated antenna available for
diversity.
For details, see
Wi-Fi+BT Module on page
For details, see
NFC on page
Purpose: Provide audio capability to CF3 module.
Default microphone: Integrated digital microphone.
Resistor pop/depop required to configure device to use
3.5 mm connector.
For details, see:
Audio (Analog and PCM) on page 19
•
MUXing on page 18
•
31.
31.
26.
32.
27.
41113116