Table of Contents
Advertisement
LOCAL MODE PROGRAMMING
KEY MAKE/BREAK CODES AND EXTENDED FUNCTIONS
A summary of all keyboard parameters programmable in the local mode, assigned Function
Codes and factory default settings is given in Table 3.
Table 3. Local Mode programming Function Codes and Default Settings
FUNCTION
CODE
00
Program Keyboard Primary Keys
01
Program Keyboard Secondary
Keys
02
Copy Primary Keys to Secondary
Keys
03
Program Primary OPOS Keys
04
Program Secondary OPOS Keys
08
Enable/Disable Magnetic Stripe
Reader (MSR) Tracks
09
MSR Beep Configuration
10
MSR Track 1,3 Prefix
11
MSR Track 1,3 Field Separator
Series 600 POS Keyboard
PARAMETER
DEFAULT
SETTING (XXh
= Hex Code in
ASCII)
See default
Used to program primary keys on
(Appendix A)
Series 600 Keyboard. The keys can
be programmed to have primary and
secondary levels of function. The
primary function is activated when only
the designated key is pressed. The
secondary function is activated when
both the Sec Op key and designated
key are depressed. Use Function
Code 01 to program secondary key
functions.
See default
See remarks above.
None
Used to copy primary key code into
key secondary position
None
To be used in conjunction with UTC
OPOS drivers.
None
To be used in conjunction with UTC
OPOS drivers
Channels 1,2
The magnetic card reader can read
enabled
three formats of information, two at
any one time, on standard format
cards. This function is used to select
which tracks on the MSR are enabled
and/or disabled.
Beep on good
Useful for indicating a good or bad
and bad read
reading when card swiped through
reader. (Uses different tones)
% (25h) for
Used to send a prefix before the
format 1
magnetic card track data.
;(3Bh) for
format 3
^(5Eh) for
Used to send a field separator
format 1 =
between fields of magnetic card data.
(3Dh) for
format 3
30
REMARKS
Advertisement
Table of Contents
